Aluminium-plastic film crushing and sorting equipment

The waste aluminium-plastic crushing and sorting equipment adopts the physical crushing and electrostatic sorting method to separate aluminium and plastic. Firstly, the medicine plate is coarsely crushed into flakes below 10mm by the knife cutting crusher, then it enters the high speed mill to finely crush the flakes into a mixture of aluminium and plastic, using the principle of electrostatic sorting machine to separate aluminium and plastic. The loss of both aluminium and plastic is very low and the aluminium reuse rate is close to over 99%. The sorted plastic can be recycled again. The equipment uses completely dry physical separation, which does not cause secondary environmental pollution and has good social and economic benefits.

Features of the aluminium-plastic recycling equipment

1、 High automation procedure, simple operation and stable performance;

3、 Separation efficiency of 99% by electric separation, finished products can be sold directly;

5、 No waste water and waste gas emission, real green sorting, no secondary pollution generation;

2、Low power consumption, low noise, small footprint, no dust pollution;

4、 Wide range of sorting materials, fast sorting speed;

6、Aluminium-plastic sorting and reuse processing equipment adopts air-cooled mill, the materials are separated more cleanly and adapt to a wider range of materials.

Aluminum and plastic recycling equipment for materials:

Waste aluminium and plastic crushing and sorting equipment is to thoroughly separate the aluminium and plastic compound materials into aluminium and plastic equipment. The raw materials come from pharmaceutical factories, aluminium-plastic sheet factories, aluminium-plastic tubes, food and beverage factories and other aluminium foil packaging industry's edge waste, waste soft packaging bags, capsule plates, toothpaste skins, wowhaha bottles etc. from scrap stations are also applicable.